Rust item sorter circuit

An industrial splitter feeds two conveyors from the same box: one filters metal and sulfur ore into the ore box, the other is set to Not with the same filter and takes everything else. Each conveyor moves every 5 seconds.

How to wire it

  1. Medium Rechargeable Battery "Power Output" → Splitter "Power In"
  2. Splitter "Power Out 1" → Industrial Conveyor "Power In"
  3. Splitter "Power Out 2" → Industrial Conveyor "Power In"
  4. Large Wood Box "Industrial Out" → Industrial Splitter "Industrial In"
  5. Industrial Splitter "Industrial Out 1" → Industrial Conveyor "Industrial Input"
  6. Industrial Splitter "Industrial Out 2" → Industrial Conveyor "Industrial Input"
  7. Industrial Conveyor "Industrial Output" → Large Wood Box "Industrial In"
  8. Industrial Conveyor "Industrial Output" → Large Wood Box "Industrial In"
Open a blank editor

Ready circuits

Open one in the editor, test it and change it.

How Rust electricity works

Power in Rust is pushed, not pulled: a source sends everything it makes down the wire, and each component decides what to pass on. A splitter divides what comes in evenly between the outputs that have a wire, without looking at what each one needs; whatever isn't used is lost. A branch sends a fixed amount out of Branch Out and the rest straight on.

Batteries are the exception that makes bases work: a battery always pushes its full output (15, 50 or 100), but it only spends what the things wired after it actually use. That's why a battery feeding a turret and a light through a splitter drains 11 per second, not 50. It charges at 80% of what comes in.

Most components that only route power use none: splitters, branches, switches, timers, counters and logic gates. Lights, sensors, RF and door controllers use 1, the auto turret 10, the SAM site 25. A component that gets less than it needs doesn't run and doesn't spend anything.

© 2026 Vestigo